Installing SpaceX’s Starlink with the volcano roof mount. Running speed tests and comparing Starlink to Telus Smart Hub. Rural internet solution!𝐃𝐫𝐢𝐩 𝐋𝐨𝐨𝐩: "a downward hanging loop in a line that runs to a building"A very important step that was missed and pointed out in the comments is using a drip loop. I should have ran the line below the wall penetration, then back up before entering the wall. This will allow any water that might travel down the line to drip to the ground and not direct it towards the wall. See 7:34 for an example of a drip loop.𝗔𝗺𝗮𝘇𝗼𝗻 𝗔𝗳𝗳𝗶𝗹𝗶𝗮𝘁𝗲 𝗟𝗶𝗻𝗸𝘀Cover Plate Retro-fithttps://geni.us/A2538TCover Plate Box Requiredhttps://geni.us/QHkq1 ½” SS Exhaust Clamphttps://geni.us/DKFr1 ½” SS Hose Clamphttps://geni.us/9F3V𝐓𝐢𝐦𝐞 𝐒𝐭𝐚𝐦𝐩𝐬0:00 Unboxing0:26 Installation Plan2:43 Install9:22 Setup10:15 Recap11:24 Speed Tests12:01 Starlink vs Telus𝗦𝘂𝗽𝗽𝗼𝗿𝘁Want to support my channel or give back? Help me improve on these DIY videos by making a financial contribution. All contributions no matter how small are greatly appreciated!https://ko-fi.com/prosdiyThank you!𝗖𝗼𝗻𝗻𝗲𝗰𝘁More DIY videos! https://www.prosdiy.comFacebook: https://www.facebook.com/prosdiyInstagram: https://www.instagram.com/prosdiySubscribe: https://www.youtube.com/c/prosdiyAmazon: https://www.amazon.com/shop/prosdiyDisclosure: Pros DIY is an Amazon Associate. We earn a small commission from qualifying purchases through our affiliate links at no additional cost to you.Videos produced by Pros DIY (https://www.prosdiy.com) are provided for informational purposes only. Please check with all national, state, provincial, and local codes and regulations before attempting any work. Pros DIY does not assume any responsibility or liability for any damage or injury from the information provided in our videos. Please hire a licensed, certified, professional.